To Next PageTo Next Page
Need help?Do you have a question about the EUTECH INSTRUMENTS ECTest11 and is the answer not in the manual?
General| Conductivity Resolution | 1 µS/cm |
|---|---|
| TDS Resolution | 1 ppm |
| Temperature Range | 0 to 50 °C |
| Temperature Resolution | 0.1 °C |
| Temperature Accuracy | ±0.5 °C |
| ATC | Yes |
| Operating Temperature | 0 to 50 °C |
| Conductivity Range | 0 to 20.00 mS/cm |
| Conductivity Accuracy | ±1% of full scale |
| TDS Range | 0 to 1999 ppm |
| TDS Accuracy | ±1% of full scale |
| Power | 4 x 1.5V batteries |
Allows setting a specific measuring range for testers when default AUTO is not sufficient.
Explains automatic/manual calibration and single/multi-point selection for Eutech testers.
Guide for enabling/disabling Auto Calibration (AC) on specific Eutech models.
Instructions for selecting between 1-point or multi-point calibration modes.
Steps for taking measurements with the Eutech tester, including sensor dipping and stabilization.
How to freeze the displayed measurement value and how to release it.
Adjusting the TDS factor for TDS models, with default value and adjustment range.
Procedure for calibrating the temperature reading on the tester.
Steps to restore the tester to its original factory settings.
Instructions for cleaning and storing the sensor for optimal performance.
Procedure for replacing the tester's batteries.
Detailed steps for removing and installing a new sensor module.
