LS Series Coolers and Condensers
6
Figure 9 – Small Coil Section Figure 10 – Large Coil Section (2 Coils Wide)
The recommended method for extended lifts is to use slings under the unit as shown in Figures 11 and 12. Spreader bars should
always be used between the cables at the top of the section to prevent damage to the upper flanges.
NOTE: The U-bolts or other lifting points should be used for final positioning only and for lifting where no danger exists. If
they are used for extended lifts, safety slings and spreader bars should be provided under the sections as shown.
Figure 11 – Extended Lift Small Coil Section Figure 12 – Extended Lift Large Coil Section
To Next Page
Loading...
