Evco c-pro 3 NODE kilo+ - Page 27

EVCO S.p.A. c-pro 3 NODE kilo+ | Hardware manual ver. 1.0 | Code 114CP3NKPE104
CAN CANBUS communication LED
if it is on, the device is configured to communicate via CAN CANBUS with another device, but the communication has not
been established
CAN
if it is flashing slowly, the CAN CANBUS communication has been established, but is not entirely correct
if it is flashing quickly, the CAN CANBUS communication shall established and be entirely correct
if it is off, no CAN CANBUS communication is in progress
Auxiliary LED
L1
The operation of this LED can be set via the UNI-PRO 3 development environment
For additional information, please refer to the following chapters.
page 27 of 55