Evco c-pro 3 NODE kilo+ - Table of Contents

EVCO S.p.A. c-pro 3 NODE kilo+ | Hardware manual ver. 1.0 | Code 114CP3NKPE104
Index
1 INTRODUCTION...............................................5
1.1 Introduction ....................................................5
1.2 Summary table of available models, their main
characteristics and purchase codes ....................6
2 DESCRIPTION .................................................9
2.1 Description .....................................................9
3 DIMENSIONS AND INSTALLATION ...................11
3.1 Dimensions:..................................................11
3.2 Installation....................................................11
3.3 Installation warnings ......................................12
4 ELECTRIC CONNECTION .................................14
4.1 Connectors ...................................................14
4.2 Meaning of connectors....................................14
4.3 Insertion of the termination resistor of the CAN
CANBUS port.................................................21
4.4 Insertion of the RS-485 MODBUS master/slave
port termination resistor .................................21
4.5 Insertion of the RS-485 MODBUS slave port
termination resistor........................................21
4.6 RS-485 MODBUS master/slave port polarisation 21
4.7 RS-485 MODBUS slave port polarisation ........... 21
4.8 Example of electric connection.........................22
4.9 Warnings for the electric connection.................24
5 USER INTERFACE...........................................26
5.1 Keypad .........................................................26
5.2 LED warning lights .........................................26
6 CONFIGURATION ...........................................28
6.1 Configuration of abuilt-in LCD programmable
controller ......................................................28
6.2 Configuration of a blind programmable controller
...................................................................29
6.3 I/O expansion configuration ............................30
6.4 Configuration of a programmable controller
through a remote user interface ......................31
6.5 List of configuration parameters ......................33
7 ACCESSORIES ...............................................45
7.1 0810500018/0810500020 connection cables .....45
7.2 4GB EVUSB4096M USB flash drive ...................45
7.3 Non opto-isolated RS-485/USB serial interface
EVIF20SUXI ..................................................45
7.4 Cut phase speed regulator for EVDFAN1 single-
phase fans ....................................................46
7.5 CJAV36 connection kit ....................................46
8 TECHNICAL DATA ..........................................47
8.1 Technical data ...............................................47
page 3 of 55