Evenflo Everystage lx - Page 16

3130
EasyClick™
IMPORTANT: Make sure both lower anchor connectors are
facing upward and the straps are not twisted.
4
5
1
2
3
this
side
UP
this
side
UP
Lift pad off front edge
of seat as shown.
Attach lower anchor / UAS
connectors to the vehicle
lower anchor bars until
they lock onto the bars on
both sides of the seat.
4
5
3
2
1
FORWARD-FACING
REAR-FACING
this
side
UP
this
side
UP
Correct
4
5
3
2
1
FORWARD-FACING
REAR-FACING
Incorrect
4. Ensure child restraint is secure.
- To secure a child restraint that has EasyClick™
connectors, go to Step 4a.
- To secure a child restraint that has Quick Connectors ,
go to Step 4b.
4a.
4
5
1
2
3
this
side
UP
this
side
UP
Tighten the strap by moving
the handle back and forth on
the lower anchor connector as
shown until the seat is tight.
Fold handle up after tightening.
CLICK!
this
side
UP
this
side
UP
Correct
Incorrect
Quick Connector™
IMPORTANT: Make
sure both lower anchor
connectors are facing
upward and the straps
are not twisted.
4
5
1
2
3
Lift pad off front edge
of seat as shown.
Attach lower anchor / UAS
connectors to the vehicle
lower anchor bars until they
lock onto the bars on both
sides of the seat.
Using your full weight, push
the child restraint firmly
into the vehicle seat while
pulling up on the Lower
Anchor Strap to tighten, as
shown.
4b.
Test for tightness. If you can move the child restraint
more than 2.5 cm (1 in.) side to side or front to back at
the rear-facing belt path, the lower anchor connector
assembly strap is not tight enough.
You will need to try again, find another location for
your child restraint, or install with the vehicle seat
belt (p. 33).
Re-attach the seat pad.
Rear-facing Installation with Lower
Anchor (UAS) Connectors (cont.)
Rear-facing Installation with Lower
Anchor (UAS) Connectors (cont.)
4
5
1
2
3
CLICK!
4
5
3
2
1
FORWARD-FACING
REAR-FACING
this
side
UP
this
side
UP
CLICK!
5.