EasyManua.ls Logo

Evenflo Everystage lx - Converting to Booster Mode

Evenflo Everystage lx
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5756
Converting Seat into Booster Mode
1.
2.
3.
Loosen harness straps by
pushing the harness release
button on the front of the
seat. At the same time, pull
on the harness straps.
Raise the headrest to
highest position (p.58).
Unfasten the chest clip
and buckle.
Remove the crotch buckle
from the crotch slot.
Recline the seat to Recline
Position 1 and turn the
anchor and push it up
through slot in the seat.
Pull crotch buckle off seat.
Unfasten two snaps at the
harness slot openings where
the shoulder straps come
out then unfasten snaps
on the inside of the
seating area.
Pull the back pad forward.
Push the shoulder straps
behind the headrest pad.
PLACE
AT
ARMPIT
Anchor
Snaps
Converting Seat into Booster Mode
(cont.)
4.
5.
6.
Adjust booster seat
to Recline Position
5-ONLY (p. 58).
Booster Mode is
complete.
Reverse steps to convert
back to Forward-facing
harness mode.
Snaps
Reassemble the loose
crotch buckle onto the
shoulder straps and
fasten the chest clip.
Flip the crotch buckle
over the assembled
chest clip.
Push the fully assembled
harness into the open
compartment as shown.
Raise back pad and
fasten the two snaps
on side of seat pad
then lower the
headrest pad.
Re-fasten the snaps
at the shoulder strap
openings.

Related product manuals