Evenflo Everystage lx - Child Securing and Restraint Management; Adjusting Headrest and Harness

5958
General
To adjust, squeeze the headrest
adjust lever, as shown, while
sliding the headrest up or
down to the desired position.
When the headrest is in one
of the locking positions, the
adjust lever will pop into its
original position.
Note: You may need to loosen
the harness straps to adjust the
headrest (p. 62).
Adjusting the Headrest/
Harness Position
Reclining Child Restraint
3
2
1
4
5
DO NOT USE WITH
LAP BELT ONLY.
Top of ears are
below top of
child restraint headrest
The belt guides
should be even
WITH or
JUST ABOVE
the shoulders
Shoulder
Belt Path
Guide
Forward-Facing
To raise or lower
the recline, pull
the handle out
in front edge of
seat and push or
pull seat into the
desired recline
position as shown.
REAR-FACING POSITIONS FORWARD-FACING POSITIONS
Rear-facing: Start with the headrest in its lowest
position. Adjust headrest so the harness straps are at or
just below the child’s shoulders.
Forward-facing: Start with the headrest in its highest
position. Adjust headrest so the harness straps are at or
just above the child’s shoulders.
Lever
When the seat is reclined
to Recline Positions 1 , 2
or 3 the ball must fall into
the green zone as shown.
When the seat is placed into
Recline Positions 4 or 5 , the
ball must fall into the blue
zone as shown.
4
5
3
2
1
DO NOT USE WITH
LAP BELT ONLY.
Top of ears are
below top of
child restraint headrest
The belt guides
should be even
WITH or
JUST ABOVE
the shoulders
Shoulder
Belt Path
Guide
Forward-Facing
4
5
3
2
1
DO NOT USE WITH
LAP BELT ONLY.
Top of ears are
below top of
child restraint headrest
The belt guides
should be even
WITH or
JUST ABOVE
the shoulders
Shoulder
Belt Path
Guide
Forward-Facing
FORWARD-FACING
REAR-FACING
3
2
1
4
5
DO NOT USE WITH
LAP BELT ONLY.
Top of ears are
below top of
child restraint headrest
The belt guides
should be even
WITH or
JUST ABOVE
the shoulders
Shoulder
Belt Path
Guide
Forward-Facing
FORWARD-FACING
REAR-FACING
1
2
3
4
5
PLACE
AT
ARMPIT
To reposition the crotch
strap, first recline the seat
to Recline Position #1
(p. 58). Looking under
the front of the seat, turn
the crotch strap harness
anchor sideways and push
it through the slot in the
bottom of the seat shell.
Reposition the crotch strap
into the other slot. Make
certain the crotch strap is
properly seated against the
seat shell.
Note: The crotch strap
should be snug against the
child. Choose the slot that is
closest to the child AND the
most comfortable for the
child but NEVER under the
child’s bottom.
For Newborn Position
Place the anchor through the front slot, then feed it
through the rear slot.
Make sure the anchor is completely
through the rear slot and is lying
flat against the bottom of the seat.
IMPORTANT: Do not use this
configuration for infants weighing
more than 4.5 kg (10 lbs).
This child restraint has two Crotch Strap positions:
Adjusting the Crotch Strap
Position
Anchor
Slot
Seat
shell
Anchor
Anchor
through
rear slot
Bottom view