17
Installation with LATCH
4. Secure the child
restraint.
Using your full weight,
push the child restraint
firmly into the vehicle
seat while pulling up
on the LATCH strap to
tighten.
LATCH
Belt Path
IMPORTANT: To properly protect the child, the child
restraint MUST NOT move more than 25 mm (1 inch) from
side-to-side or from front-to-back at the LATCH belt path.
If you cannot tightly secure the child restraint, try again or
move it to another location.
LATCH
Lower Anchor
LATCH
Lower Anchor
Near Side
Far side
3. Attach LATCH Connectors.
Attach a LATCH connector onto each seat anchor.
IMPORTANT: Make sure both LATCH connectors are facing
upward and the harness straps are not twisted.
Using with the 5-pt Harness
To Next Page
Loading...
