31
1. Convert child restraint to booster seat.
See “Converting into a Booster Seat,” p. 32.
2. Secure booster seat to the vehicle seat.
a
Make sure the bottom and back of the booster seat
are touching vehicle seat and back.
a
If your vehicle has LATCH, you may secure
the booster seat to the vehicle with the
LATCH connectors, p. 17.
3. Place the child in the booster seat.
Make sure the child’s back and bottom are flat against
the back and bottom surfaces of the booster seat.
4.
Secure child and booster seat to vehicle seat.
Stretch the lap/shoulder belt across the child and
fasten the buckle. Make certain the shoulder belt
is threaded through the shoulder belt guide.
5. Check your work.
Make sure the lap belt is stretched low and snug
across the child’s hips, within the belt guides, and
fastened into the buckle. The shoulder belt must cross
the child midway between his/her shoulder and neck.
Booster Installation Checklist
WARNING
•
The shoulder belt MUST NOT cross the child’s neck or fall
off the child’s shoulder. If you cannot adjust the shoulder
belt to properly lay midway between the child’s shoulder
and neck AND at or above the shoulder, try another
seating location, or do not use the booster seat.
• DO NOT use the locking clip in booster mode.
To make installation easier, watch the installation
video of this booster seat at www.evenflo.com.
Tip!
Tip!
Using as a Booster Seat
To Next Page
Loading...
