Evenflo Triumph - Forward-facing Installation with Seat Belt; Recline Positions & Belt Routing; Seat Belt Fastening & Flap Use

3130
TOC
The child must weigh
10 to 22.7 kg
(22 - 50 lb.).
1
Forward-facing Installation with Seat Belt
A
Adjust the recline to Positions #2 or #3 by lifting the
back of the seat slightly while pulling the ReclineRight
lever
A
.
Intermediate Recline Position (Position #2)
Full Upright Position (Position #3)
2
The Intermediate Recline Position (Position #2)
and Full Upright Position (Position #3) are ONLY
for forward-facing use. Always make sure the
bottom of the child restraint sits flat on the vehicle
seat.
If the vehicle seat belts are not routed correctly,
the child restraint may not protect your child in a crash.
Route the vehicle seat belt
through the child restraint.
Use the BeltTrac access
flap
B
for easier seat belt
routing.
Buckle the vehicle seat belt.
B
3
4
The child must weigh
10 to 29.4 kg
(22 - 65 lb.).
Fasten the vehicle seat belt as shown depending on your
type of seat belt.
Note: Install locking clip on lap and shoulder belt
combinations, if necessary.
Lap and Shoulder
Belt Combination
Lap Belt Only
5
DO NOT allow the vehicle seat belt release button to touch
the child restraint. Accidental contact may cause the seat
belt to release. If necessary, turn the vehicle seat belt button
away from the child restraint or move the child restraint to
a different location.
Forward-facing
WARNING
WARNING