EasyManuals Logo

Event Lighting DIM4 User Manual

Event Lighting DIM4
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
www.event-lighting.com.au
2
Safety Instructions
Warning
Do not open this device, there are no user serviceable parts inside. Risk of electric
shock.
CAUTION: This unit’s housing may become hot during and after operation.
Install this device in a location with adequate ventilation, at least 20 inches (50 cm) from
adjacent surfaces.
Do not leave any flammable material within 20 inches (50 cm) of this unit while operating
or connected to power.
Use a safety chain when mounting the device overhead.
Do not operate this device outdoors or in any location where dust, excessive heat, water
or humidity may affect it.
Do not operate this device if the housing, lenses, or cables appear damaged.
Only connect this device to a grounded and protected circuit.
Only use the hanging bracket to carry this device.
In case of a serious problem, stop using this device immediately.
Do not operate this device at ambient temperatures higher than 40° C (104° F).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Event Lighting DIM4 and is the answer not in the manual?

Event Lighting DIM4 Specifications

General IconGeneral
BrandEvent Lighting
ModelDIM4
CategorySwitch
LanguageEnglish