4 For Professional Technical Support call 1-844-241-5521
Pre-Installation
APPLICATION
This unit is a submersible effluent pump and designed for pumping effluent, wastewater or flooded water with up to 3/4 in. solids. The
pump is built with overload thermal protections and auto reset. The pump is equipped with a 25 ft. 3-prong grounding-type power cord and
tethered float switch. This pump operates automatically. Ball bearings on motor shafts never need lubrication.
TOOLS REQUIRED
MATERIALS REQUIRED (NOT INCLUDED)
NOTE: Parts shown below not to scale.
SPECIFICATIONS
Power supply 115V, 60 HZ., 15 Amp Circuit
Liquid temp. range
32-131°F (0-55°C)
Discharge size
2 in. FNPT
Sump basin
Minimum 18 in. (460 mm) diameter, 30 in. (760 mm) depth
Switch on/off
On: 13.3 in. (338 mm), Off: 5 in. (127 mm)
NOTICE: Read this Owner’s Manual for installation, operation, and safety information.
Phillips
Screwdriver
Flathead
Screwdriver
Safety
goggles
Pipe wrench Channel
Locks
Cable
Ties
Tape
Measure
Hacksaw
Threaded Adapter
(Pipe to Pump)
2 in. ABS or
PVC Pipe
Thread Tape
2 in. check valve
ABS or PVC Cement (to
match the pipe)
2 in. 90° Elbow
Ball Valve
To Next Page
Loading...
