Everbilt SP03302VD - Troubleshooting Common Issues; Pump Not Starting or Running; Low or No Water Pumping; Frequent Pump Cycling

9 For Professional Technical Support call 1-844-241-5521
Troubleshooting
Problem Possible Cause Corrective Action
The pump does not start or run. 1. No power.
2. The impeller is blocked.
3. The float switch failed.
4. The motor failed.
1. Reset GFCI switch/Reset the
breaker/Secure the plug/Clean the
plug prongs.
2. Remove the debris around the
impeller.
3. Replace the float switch.
4. Replace the pump.
The pump operates but pumps little or
no water.
1. The screen is blocked.
2. Debris is caught in the impeller or discharge.
3. The impeller is broken.
1. Clean the screen.
2. Remove the debris.
3. Replace the impeller.
The pump starts and stops too often. 1. There is a backflow of water from the piping or
the check valve is leaking.
2. The float switch is stuck.
3. The float switch failed.
1. Install a check valve or replace the
check valve.
2. Clean the float switch.
3. Replace the float switch.
The pump will not shut off. 1. The float switch is tangled.
2. The float switch failed.
1. Reposition the pump and make sure
the switch moves freely.
2. Replace the float switch.