R
Ray GonzalezJul 29, 2025
Why is the flow rate low on my Everbilt Water Pump?
- RRachael AyalaJul 29, 2025
A low flow rate in your Everbilt Water Pump could be due to several reasons. Ensure the drill is running at the correct speed; the minimum is 800 RPM, with an optimal speed of 3500 RPM. Also, check for any restrictions in the inlet or discharge hoses; clean or replace them and eliminate any sharp bends or kinks. Finally, the suction hose might be too long, the diameter too small, or the pump positioned too high above the liquid surface; use an appropriate hose and pumping setup to maximize performance.