Everbilt HDS50 - User Manual

Questions and Answers

S
Stanley Sparks DVMJul 25, 2025
How to troubleshoot Everbilt HDS50 Water Pump that does not turn on?
- B
  bjonesJul 25, 2025
  If your Everbilt Water Pump isn't turning on, start by ensuring it's properly plugged in. Then, check your circuit breaker to see if it has tripped or if a fuse is missing and replace the fuse or turn on the breaker if necessary. Also, make sure that the float is free of debris and obstructions. If these steps don't resolve the issue, the switch or the motor may be defective, requiring service by an authorized service center.
J
John FloresJul 31, 2025
What to do if Everbilt HDS50 runs but does not discharge liquid?
- R
  Robert RoseJul 31, 2025
  If your Everbilt Water Pump runs but doesn't discharge liquid, start by checking the check valve to ensure it's correctly installed with the flow indicating arrow pointing in the right direction. Also, the check valve might be stuck or plugged, so remove it and inspect it for proper operation. Another potential issue is that the lift might be too high for the pump's capacity, so check the rating table. Lastly, the inlet to the impeller could be plugged, requiring you to pull the pump and clean it. If the pump is air locked, shut the power off for approximately 1 minute and restart. Repeat several times to clear air from the pump.
G
George KelleyAug 7, 2025
Why Everbilt Water Pump will not shut off?
- J
  Joseph GonzalezAug 7, 2025
  If your Everbilt Water Pump won't shut off, there might be an obstruction in the float or float rod path, so check and clear any obstructions. Another potential cause is the pump being air locked; try shutting off the power for about a minute and then restarting it, repeating this several times. Also, if the liquid inflow matches the pump capacity, a larger pump might be necessary. If none of these solutions work, the switch might be defective, and you should have the pump serviced by an authorized service center.
M
Matthew Rodriguez MDAug 12, 2025
What to do if Everbilt Water Pump does not deliver the rated capacity?
- R
  Russell LoweAug 12, 2025
  If your Everbilt Water Pump isn't delivering its rated capacity, first check the rated pump performance to ensure the lift isn't too high for the pump. Next, verify that the supply voltage corresponds to the voltage on the nameplate, as low voltage can slow the speed. Additionally, the impeller or discharge pipe could be clogged, so pull the pump and clean it, checking the pipe for scale or corrosion. Finally, if the impeller is worn due to abrasives, consider replacing it.
M
Michael CastilloAug 18, 2025
Why does my Everbilt HDS50 continually cycle?
- T
  Timothy ReillyAug 18, 2025
  If your Everbilt Water Pump continually cycles, it might be due to the absence of a check valve in the long discharge pipe, which allows liquid to drain back into the sump. In this case, install a check valve in the discharge line. Alternatively, the existing check valve might be leaking, so inspect it for correct operation. Lastly, if the basin is too small for the inflow, consider installing a larger basin.