EasyManua.ls Logo

Everbilt EFLS10-HD - User Manual

Everbilt EFLS10-HD
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
THANK YOU
We appreciate t
he trust and confidence you have placed in Everbilt through the purchase of this pump. We strive to continually create quality
products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs. Thank you for
choosing Everbilt!
Item #1001 092 236
1001 092 238
1001 092 241
M
odel #EFLS10-HD
EFLS15-
HD
EFLS20-HD
USE AND CARE GUIDE
PLASTIC LAWN SPRINKLER PUMP
Questions, problems, missing parts? Before returning to the store,
call Everbilt Customer Service
8 a.m. - 6 p.m., EST, Monday-Friday
1-844-883-1872
HOMEDEPOT.COM

Table of Contents

Questions and Answers

  • P
    pamelaowensJul 29, 2025
    What to do if my Everbilt EFLS10-HD does not deliver water to full capacity?
    • D
      Daniel McbrideJul 29, 2025
      If your Everbilt Water Pump isn't delivering water to its full capacity, it could be due to several reasons. If the water level in the well is lower than estimated, a deep well jet may be needed if the depth to water exceeds 25 ft. Corroded or limed steel piping can cause excess friction; replace it with plastic pipe where possible, or with new steel pipe. Insufficient piping size can also restrict water flow, so use larger piping. Finally, the pump might not be receiving enough water, in which case you should add additional well points.
  • J
    Jessica BradfordAug 4, 2025
    What to do if my Everbilt EFLS10-HD motor will not run?
    • J
      jasonmcdonaldAug 4, 2025
      If your Everbilt Water Pump motor isn't running, there are several potential causes. First, check if the disconnect switch is turned on. Next, inspect the fuse to see if it's blown or the circuit breaker has tripped; replace the fuse or reset the breaker if needed. A defective pressure switch could also be the culprit, in which case you should disconnect the power and replace the switch. Finally, examine the wiring at the motor to ensure it's correctly wired and all connections are secure, referring to the wiring instructions and disconnecting power before checking.
  • M
    Mark OnealAug 15, 2025
    What to do if my Everbilt EFLS10-HD Water Pump motor runs hot and overload kicks off?
    • Q
      qpatrickAug 15, 2025
      If your Everbilt Water Pump motor runs hot and the overload kicks off, or if the motor only hums and doesn't run, it could be due to incorrect wiring. Refer to the wiring instructions to ensure it is properly connected. Another cause might be low voltage. Check with the power company and consider installing heavier wiring if the current wiring is too small, referring to the wiring chart.
  • X
    xtaylorAug 22, 2025
    What to do if my Everbilt EFLS10-HD leaks around the clamp?
    • M
      maria03Aug 22, 2025
      If your Everbilt Water Pump is leaking around the clamp, the clamp may be loose. Stop the pump and tighten the clamp nut by 1-2 turns. Alternately tighten and tap on the clamp with a mallet to seat the O-ring, being careful not to overtighten.
  • S
    Shannon NelsonNov 9, 2025
    Why does my Everbilt EFLS10-HD motor run but no water is delivered?
    • O
      ocampbellNov 9, 2025
      If your Everbilt Water Pump motor runs but no water is delivered, several issues could be the cause. Ensure the pump was primed correctly according to the instructions. Check for air leaks in all connections on the suction line, shaft seal, and AVC, using shaving cream to identify leaks. A leaking foot valve or check valve may also be the problem, requiring replacement. Additionally, verify that the pipe size matches the suction and discharge ports on the pump. If the water level is below the suction pipe inlet, lower the suction line into the water and re-prime; a deep well pump may be necessary if the water level exceeds 25 ft. A plugged impeller can also prevent water delivery, so clean it. If the check valve or foot valve is stuck shut, replace it. Frozen pipes can also block water flo...

Summary

Safety Information

General Operating Precautions

Covers precautions against explosion and electric shock during operation.

Safety Symbol Definitions

Explains the meaning of DANGER, WARNING, CAUTION, and NOTICE symbols.

Critical Safety Warnings

Details specific critical safety warnings related to pump usage and environment.

Warranty

Pre-installation

Installation Considerations

Key factors to consider before installing the pump for optimal performance and safety.

Installation

Well Pipe Installation Methods

Guidance for installing the pump with various well pipe configurations.

Cased Well;Dug Well Installation

Step-by-step instructions for pump installation in cased or dug wells.

Driven Point Installation

Instructions for installing the pump with a driven point water source.

Surface Water Installation

Methods for vertical and horizontal installation from surface water sources.

Lawn Sprinkling Application

Information on using the pump for lawn irrigation systems.

Pump and Piping Installation

Guidance on installing the pump and associated piping for proper operation.

Pipe Sizing for Suction

Recommendations for selecting pipe size for optimal suction performance.

Pipe Sizing for Discharge

Guidance on increasing pipe size for discharge to reduce pressure loss.

Electrical Information

Motor Voltage Configuration

How to set the motor wiring for 115V or 230V power supply.

Wiring Diagrams and Connections

Details wiring diagrams and crucial connection safety guidelines.

Operation

Wire and Fuse Sizing

Recommended wire and fuse sizes for 115V and 230V operation.

Priming the Pump

Step-by-step procedure for expelling air and starting water flow.

Care and Maintenance

Clearing Pump Debris

Instructions for clearing debris from a clogged pump.

General Maintenance

Notes on ensuring adequate ventilation and bearing lubrication.

Winterization Procedure

Steps to take to prevent pump and pipe damage from freezing.

Troubleshooting

Troubleshooting Guide

Common problems, their probable causes, and corrective actions.

Service Parts

Everbilt EFLS10-HD Specifications

General IconGeneral
BrandEverbilt
ModelEFLS10-HD
CategoryWater Pump
LanguageEnglish

Related product manuals