APPLIANCE DETAILS
Voltage: 220-240V
Frequency: 50Hz
Lamp Max: 2x40W halogen lamps
Rated Input Power: 270W
GENERAL INFORMATION
Before installing and operating the range hood, carefully read the following important information regarding
installation safety and maintenance. Keep this information booklet accessible for further consultations.
The appliance has been designed to exhaust cooking fumes externally. Before installation, please ensure that
the following have been supplied and that the tools listed below are readily available.
WHAT IS SUPPLIED
Range hood (including one way valve for flue x 1) x 1.
Installation kit x 1 –14mm screws x 8.
WHAT MAY BE NEEDED FOR INSTALLATION
Electric Drill Duct Tape
Tape Measure Jig Saw
Spirit Level Ladder
Screwdrivers Torch (If natural lighting is minimal)
INSTALLATION INSTRUCTIONS
Please ensure that before installing the range hood, all power is switched off.
Installation must be in accordance to the local electrical authority and codes.
This range hood must be earthed at all times for the operators’ safety.
The switched power outlet for the range hood should be positioned to enable the user to turn the power off,
to enable cleaning and any maintenance required.
The switched power outlet should be installed within 600mm from the rear of the unit.
Ensure that when installing the range hood, that it is protected from any possible damage from tools etc.
Ducting for this unit must be installed in accordance to the local authority.
Ensure that the fixings used for this range hood are suitable.
Check the area where the range hood is to be fitted, to ensure that it is structurally sound.
The Everdure RUES51 & RUES71 range hoods are intended to be installed directly into a cupboard above a
cooking appliance.
Lifting and fixing the range hood into position is a 2 person job.
The maximum installation space for the range hoods are:
RUES51 - (W)525mm x (D)300mm x (H)289mm
RUES71 - (W)700mm x (D)300mm x (H)289mm
4
To Next Page
Loading...
