Everflo EF 1200 - Page 26

26
• Also follow the instructions contained in the use and maintenance manual of the machine in which
the motor pump is integrated.
• Make sure all deliveries are closed or connected to accessories that have been turned o (e.g., tap in “OFF”
position).
• Check the tightness of the clamps connecting the pipes to their ttings.
• Make sure that the moving parts of the motor pump are suitably protected and that they are not accessible
to unauthorised persons.
• Do not use the motor pump (and therefore the machine in which it is integrated) in the event of:
- the supply cable or other important parts such as the high-pressure pipes and the safety devices being
damaged;
- its having suered heavy knocks;
- evident leaks of pumped liquid.
In such cases, have the motor pump and the machine in which it is integrated checked by a Skilled Technician.
• Have a Skilled Technician perform the inspections required by special maintenance.
• Wear clothing and personal protective equipment able to provide adequate protection from any high-pressure
jets and chemical products used.
Carry out the preliminary activities indicated in the manual of the machine in which the motor
pump is integrated.
CAUTION
• In case of operation at very low temperatures, make sure there is no ice inside the motor pump and
pipes.
CHECKING AND CONNECTING UP TO THE POWER SUPPLY
WARNING
• Also follow the instructions contained in the manual of the machine in which the motor pump is
integrated.
• In the event of powering the motor pump with a battery, pay attention to the fact that it contains hazardous
liquid, may emit explosive gas and can cause electric shocks, therefore:
- always use protective goggles;
- do not smoke or place heat sources near the battery;
- do not touch both battery terminals with the hands or metal tools;
- immediately wash any parts that come into contact with uids leaking from the battery;
• Have the battery replaced when required only by a Skilled Technician.
PRECAUTIONS CONCERNING PUMPED CHEMICAL PRODUCTS
WARNING
• Also follow the instructions contained in the manual of the machine in which the motor pump is
integrated.
• Store the chemical products in ventilated premises, with door equipped with lock. The products must be out
of reach of children and unauthorised persons. Place hazard notices outside the premises.
• Carefully read the safety instructions and precautions on the chemical product packs, so as to be able to take
suitable measures to prevent hazards aecting people and the environment. In particular, do not exceed
maximum recommended concentrations and only prepare the quantity of product needed to avoid dispersion
on the ground and in the water system.
• In case of contact with eyes, immediately rinse with water. In case of swallowing, do not induce vomit:
immediately contact a doctor, and show him/her the pack of detergent. Avoid inhaling any gases produced.
• Always wear adequate protection gear and keep away children, unauthorised persons and personnel not
adequately protected. Do not drink, eat and smoke.
• At the end of the various operations, carefully wash your hands and face.
• Carefully wash any clothes that have come into contact with the chemical products. Any contaminated items