EverFocus ECMD200 User Manual

Covert Color Camera in
Working PIR Motion Detector Case
Operation Instructions
Model No. ECMD200
Please read this manual first for correct installation and operation. This manual should be retained for future
reference. The information in this manual was current when published. The manufacturer reserves the right
to revise and improve its products. All specifications are therefore subject to change without notice.
PRECAUTIONS
1. Do not install the camera near electric or magnetic fields.
Install the camera away from TV/radio transmitters, magnets, electric motors, transformers and audio
speakers since the electromagnetic fields generated from these devices may distort the video image or
otherwise interfere with camera operation.
2. Never disassemble the camera beyond the recommendations in this manual nor introduce
materials other than those recommended herein. Improper disassembly or introduction of
corrosive materials may result in equipment failure or other damage.
3. Try to avoid facing the camera toward the sun.
In some circumstances, direct sunlight may cause permanent damage to the sensor and/or internal
circuits, as well as creating unbalanced illumination beyond the capability of the camera to
compensate.
4. Keep the power cord away from water and other liquids and never touch the power cord with
wet hands. Touching a wet power cord with your hands or touching the power cord with wet hands
may result in electric shock.
5. Never install the camera in areas exposed to oil, gas or solvents.
Oil, gas or solvents may result in equipment failure, electric shock or, in extreme cases, fire.

EverFocus ECMD200 Specifications

General

Camera Type	Dome
Lens	3.6mm
Lens Type	Fixed
Aperture	F2.0
IR Distance	Up to 20m
Day/Night	Yes
Weatherproof	IP66
Power Supply	12V DC
IR LEDs	24 LEDs
Video Output	1.0Vp-p, 75Ω
Operating Temperature	-10°C to +50°C
Dimensions	94 x 69 mm
Image Sensor	1/3" Sony Super HAD CCD

Summary

Precautions

Electric and Magnetic Fields

Avoid installing near EM sources to prevent video distortion or interference.

Camera Disassembly and Materials

Do not disassemble beyond recommendations or use non-specified materials.

Sun Exposure

Avoid facing camera directly at the sun to prevent permanent damage.

Power Cord Safety

Keep power cords dry and avoid touching with wet hands to prevent electric shock.

Environmental Exposure

Do not install in areas with oil, gas, or solvents to prevent hazards.

Operating Environment Limits

Operate within specified temperature, humidity, and indoor conditions.

Specifications

Installation

Mounting Location and Marking

Hole Preparation and Wiring

Electrical Connections

Connect power, N.O/N.C, coaxial, and BNC connectors, observing polarity.

Attaching the Unit

PIR Detector Configuration

Sensitivity Adjustment

Dwell Time Setting

External Device Control