INSTALLATION
An ED335 camera may be mounted in two ways: surface mount and flush mount. Select the one that meets
your needs.
Installation - Surface Mount
1. Paste the drilling template on the ceiling or wall. Please refer to the drilling template below.
2. Use the appropriate tool to drill the INNER holes, and a clearance hole for the power and video wires.
Note: The minimum recommended material thickness is 1 cm.
3. Use the plastic anchors and push them into the 4 small holes, to fix the outer ring into ceiling or wall.
This Manual: http://www.manuallib.com/file/2673673
To Next Page
Loading...
