EverFocus EQH5102 - 4.1.5 3 D-DNR Settings

EZH5102 1080p Mini IR Bullet Camera
10
4.1.4 BLC
Press the Enter / Confirm button to enter the submenu.
MODE
Use the  and  buttons to select OFF and BLC. Please notice the WDR is only working on
round 7.5FPS.
BLC OSD, POS and SIZ
Select OFF to disable the BLC function, or select ON to enable the BLC function and for further setup.
After selecting an area block, enter the BLC POS / SIZ and X / Y setup page, a “POSITION” sign
displayed on the screen. Use the direction buttons to move the area to the desired position. Press
the Enter / Confirm button to confirm the position, a “SIZE” sign displayed on the screen. Use the
direction buttons to adjust the size for the area.
4.1.5 3D-DNR
Press the Enter / Confirm button to enter the submenu.
Switch to HIGH, MIDDLE, LOW and OFF to enable or disable noise reduction on dynamic
recordings.
This Manual:http://www.manuallib.com/everfocus/eqh5102-mini-ir-bullet-camera-manual.html