24
* Installation Of The Oven Feet
1. Foot attachment lath is installed on the oven from the bottom of
the oven as shown in (gure 1).Nuts are centered on these lathes in
order to screw feet. Complete the feet installation process by screw-
ing the feet to the nuts (gure 2).
2. You can balance your oven by turning the screwed feet according
to the surface type you are using.
3. If your oven has plastic food as in (gure 3) you can adjust your
ovens height from these feet as turned clockwise or anticlockwise.
Figure 1 Figure 2 Figure 3
WARNING: Do not use the door and/or handle to
carry or move the appliance.
To Next Page
Loading...