14
ELECTRICAL CONNECTION
This oven should be installed and connected correctly according to
the manufacturer’s instructions and by the authorised service.
WARNING: The electrical connections of the appli-
ance shall be made only by using grounded sockets
equipped with a grounding system laid in accordance
with the instructions.
If the place where the appliance shall be installed is not designed
for a grounded system, immediately contact an authorized service.
The manufacturer shall never be responsible for damages caused by
non-grounded sockets, to which the appliance has been plugged.
Your oven complies with protection class I. Your oven’s plug is ground-
ed; make sure that the outlet you shall connect the plug is grounded,
too. The plug shall be placed so that it can be accessed after installation.
Your oven has been produced in compliance with 220-240 V N AC /
380-415 V 3N AC 50/60 Hz. electricity supply and requires a fuse of
50 A. If your power network does not provide these specications,
contact an electrician or an authorised service.
The circuit breaker switches of the oven shall be placed so that end
user can reach them when the oven is installed.
WARNING: The power supply cable should not
touch the hot parts of the appliance.
WARNING: If the power supply cord is damaged,
this cord shall be replaced by the manufacturer or
its service agent or an equally qualied personnel to
prevent a hazardous situation.
To Next Page
Loading...