68
ALLARMS
Each alarm is characterized by a buzzer sound. Turn off the buzzer with the DOWN button
.
To view the list of alarms, see section 10.
DISPLAY PROJECT CODE
► With the card in OFF, press the STERILIZATION button
to view the project code, version and revision of the firmware on the base card and the user interface
► The DIS1 display toggles between the display of the project code and the version, while the display
DIS2 shows the code of the firmware revision on the base card.
► Press the STERILIZATION button again
to display, in the same way, the project code, version and revision of firmware installed in the
user interface.
DISPLAYING THE PROBES
► You can view the temperatures detected by the probes by pressing the PROGRAMS button for five
seconds.
.
The display DIS1 shows the label “Pr1” and the display DIS2 shows the temperature value in the
cell.
► Press the INCREASE button
to switch to display the next probe.
The labels used are Pr2 to indicate the evaporator probe, Pr3 to indicate the needle probe and Pr4 to
indicate the condenser probe.
If the condenser probe has not been enabled, the display stops at Pr3 (evaporator probe).
► Pressing the ON/OFF button
switches the card back to OFF.
To Next Page
Loading...
