Always confirm that this grill is posi oned more than 1.27 m (50 in)
1.27 m (50 in)
1.27 m (50 in)
away from any building or combus ble
materials or surface before ligh
ng it, and that no gasoline or other vola le substances are stored in the
vicinity of this grill. (See diagram to right). Otherwise, the temperature of a grease fire or of the radiated
heat might
be sufficient to ignite nearby combus
ble or vola e substances. Always locate this unit where
there will be ample combus
on and ven a on air, but never posi on it in the direct path of a strong
wind.
Never leave the grill burning while una
ended to prevent uncontrolled grease fires from erup ng.
Never attempt to move this barbecue while it is in operation or while it is still hot, to prevent possible personal injury.
Never store or use gasoline or other flammable or volatile substances in the vicinity of this unit or in the vicinity of any
other heat-generating appliance because of the danger of starting a fire.
Always confirm that the installa
on of this barbecue conforms to the requirements of all local codes or, in the absence of applicable
local codes, with the the Canadian Standards Associa
on's Natural Gas and Propane Installa on Code CAN/CGA-B149.1.
DANGER – Gas Safety
Liquid propane (LP) gas is flammable and hazardous if handled improperly. Become aware of its characteris
cs before using any
propane product.
● Propane Characteris
cs: Flammable, explosive under pressure, heavier than air and se les in pools in low areas.
● In its natural state, propane has no odour. For your safety, an odorant has been added.
● Contact with propane could cause freeze burns to the skin.
● This barbecue is shipped from the factory for propane gas use only.
● Never
use a propane cylinder with a damaged body, valve, collar or foo
ng.
● Dented or rusted propane cylinders may be hazardous and should be checked by your propane gas supplier.
GENERAL INFORMATION
1. A propane gas cylinder is required for opera on.
2. This gas grill is NOT intended for commercial use.
3. Don't obstruct the ven
a on opening of the cylinder enclosure.
To Next Page
Loading...
