EVGA Z87 - CPU Installation

EVGA Z87 Motherboard
11
Preparing the Motherboard
Installing the CPU
Be very careful when handling the CPU. Hold the processor
only by the edges and do not touch the bottom of the
processor.
Use the following procedure to install the CPU onto the
motherboard:
 Remove the protective socket cover by pulling
it straight up. Be sure not to damage any of the
pins inside the socket
 Unhook the socket lever by pushing down and
away from the socket.
 Pull the socket lever back and the load plate will
automatically lift.
 Open the load plate and make sure not to
damage any of the pins inside of the socket.
Note: After removing the CPU socket cover, it is recommended to store it in
case you ever need to transport your motherboard. If you ever remove the
CPU, it is highly recommended to reinstall the socket cover.