Evinrude E25T User Manual

44
Using Your Evinrude E-TEC Outboard
3) Tilt the outboard up.
4) Clean the intake screens of any blockage.
5) Clean the water pump indicator of any
blockage.
6) Lower the outboard.
7) Restart the engine and run at idle.
IF cleaning the screens and indicator does
not restore the water pump indicator’s steady
discharge, the engine will operate only in “get
home” mode. Return to harbor immediately.
See your Dealer.
IF cleaning the screens and indicator does re-
store the water pump indicator’s steady dis-
charge, you might have to run for two minutes
in NEUTRAL to allow the engine to cool.
If cooling is not restored, the
EMM will identify a progressive overheat-
ing condition and shut off the engine. The
engine will not restart until the engine is
allowed to cool.
After any overheat causing engine shutdown,
see your Dealer for:
• Inspection of the water pump for excessive
wear or damage.
• Inspection of the thermostat(s).
Although the S.A.F.E. mode
can help prevent engine damage, it does
not guarantee you can run your engine
indefinitely without engine damage.
Diagnostic LEDs
The Engine Management Module (EMM) has
four LED indicators located on the top corner
of the circuit board.
The LEDs provide quick reference to the sta-
tus of several outboard systems.
The LEDs can be used to identify specific
warning functions of S.A.F.E. mode activation
without ending a day on the water.
IMPORTANT: LED 1 is closest to the center
of the EMM.
To view the LEDs the engine cover must be
removed. Refer to Filling the Oil Tank on
page 20.
The LEDs identify system functions in two
modes, Start Mode and Running Mode.
As the outboard is being started, all four LEDs
should light and then go OFF in sequence.
When the outboard is running, all LEDs
should be OFF.
Running Mode
If any LED is ON while the outboard is run-
ning, it may indicate a system problem. Refer
to EMM Diagnostics Label.
LED 1, 2, or 3 ON, return to port as soon as
practical to avoid operational difficulties. See
your Dealer.
LED 4 ON indicates:
• EMM temp. ABOVE range, refer to Engine
Overheating on page 43.
• Engine temp. ABOVE range, refer to En-
gine Overheating on page 43.
• Low / No Oil condition. Refer to Filling the
Oil Tank and Priming the Oil System on
page 20.
NOTICE
NOTICE
A WARNING
The engine cover and flywheel guard are
machinery guards. Use caution when the
engine is running.
DO NOT wear jewelry or loose clothing.
Keep hair, hands and clothing away from
rotating parts.
1. EMM
2. LEDs
3. LED 1
007056
3
2
1

Evinrude E25T Specifications

General

Brand	Evinrude
Model	E25T
Category	Outboard Motor
Language	English