To Next PageTo Next Page
Need help?Do you have a question about the Evinrude E-TEC 300 and is the answer not in the manual?
General| Displacement | 3.4 L |
|---|---|
| Alternator Output | 133 Amps Total / 50 Net Dedicated |
| Fuel Induction | E-TEC Direct Injection with stratified low RPM combustion mode |
| Lubrication | Multi-point targeted oiling |
| Starting | Electric |
| Steering | Remote |
| Trim Method | Power Trim and Tilt |
| Horsepower | 300 HP |
| Fuel System | E-TEC Direct Injection |
| Recommended Fuel | 87 Octane |
| Gear Ratio | 1.85:1 |
| Exhaust | Through prop |
| Engine Type | V6 |
| Shaft Length | 20 in / 25 in / 30 in |
Provides essential rules and precautions for safe boating operation.
Explains the meaning of warning symbols used in the manual.
Information provided on the hang tag attached to the outboard.
Specifies recommended oils and requirements for Evinrude E-TEC outboards.
Critical safety warnings related to engine operation and environment.
Procedures for safely starting and stopping the Evinrude E-TEC outboard.
Details on the function and use of the engine cut-off switch.
Explains the function and operation of the power trim and tilt system.
Explains the function of the EMM and warning signals.
Chart detailing routine inspections and maintenance by engine care product and time.
Information on anodes, their function, inspection, and replacement.
Procedures for flushing the outboard with fresh water after use.
Specific winterization procedures for remote control outboards.
Guides the user through the process of installing the outboard onto a boat.
Specifies the requirements for the outboard's battery.
Importance of monitoring water pressure and how to install a gauge.
