41
ROUTINE SERVICE
FUEL AND OIL SYSTEMS
2
FUEL AND OIL SYSTEMS
Routine replacement of filters reduces the possi-
bility of foreign material restricting the incoming
fuel or oil supplies.
Replacement filter elements are available through
Evinrude/Johnson Genuine Parts.
Fuel Filter
Evinrude E-TEC V-model outboards are equipped
with a water-sensing, water-separating fuel filter.
Refer to FUEL COMPONENT SERVICING on
p. 143.
Oil Filters and Oil Reservoir
Perform visual inspections to identify oiling system
leaks. Make certain the oil tank is filled and oil
supply is not contaminated.
Serviceable oil filters are located in the oil injec-
tion tank, and in the oil supply line before the oil lift
pump(s).
Air Silencer
The air silencer on Evinrude outboards maximizes
air flow while minimizing noise.
Routine cleaning of the air silencer is recom-
mended to remove any accumulation of debris.
Hoses and Connections
Check condition of all hoses and connections in
both the fuel and oil systems:
• Visually inspect all components.
• Observe all clamps, hoses, and connections
while outboard is running.
• Replace all damaged components.
• Repair all leaks.
1. Water-separating fuel filter 005022
1. Filter, oil supply line
2. Filter, oil injection tank
004250
42785
004218
WARNING
Failure to check for fuel leakage could
allow a leak to go undetected, resulting in
fire or explosion.
To Next Page
Loading...
