67
INSTALLATION
If you have automotive battery posts, place a
starwasher on the clamp adapter first, then
the main cable, and then the wires from the
accessories.
Tighten all connections securely and coat the
installation with Triple-Guard grease.
DO NOT use wing nuts on bat-
tery connections even if they came with
the battery. Wing nuts can loosen and
cause errant warning signals or electrical
system damage.
Service
Before servicing the battery or the outboard,
remove both battery cables from the battery,
battery negative (–) cable first. Keep metal
objects from contacting either battery post.
Service electrical components
only while the outboard is NOT running.
Be careful when identifying positive and
negative battery cables and posts.
1. Main cable
2. Starwasher
3. Accessory wires
DR6496
A WARNING
Keep the battery connections clean,
tight, and insulated to prevent their
shorting or arcing and causing an explo-
sion. If the battery mounting system
does not cover the connections, install
covers. Check often to see that connec-
tions stay clean and tight.
DR5104
A WARNING
Battery electrolyte is acidic — handle
with care. If electrolyte contacts any part
of the body, immediately flush with water
and seek medical attention.
Do not use a booster battery and jumper
cables to start the outboard. Gasoline
fumes can cause explosion and fire,
resulting in property damage, personal
injury or death.
To Next Page
Loading...
Need help?
General
