EVOCA Kalea - VALIDATOR AND MDB SETTINGS; VALIDATOR; MDB

01-2018 5035 01 61
valiDator
DEcimal poiNt positioN
Set the decimal point position, i.e.:
0: decimal point is disabled
1: XXX.X (one decimal place)
2: XX.XX (two decimal places)
3: X.XXX (three decimal places)
crEDit programmiNg (ovErpay)
You can decide whether to:
-Collect any credit in excess of the selec-
tion amount after a certain time in seconds
(parameter "000 deleted").
-Leave any credit in excess of the selection
amount available for a subsequent selec-
tion (parameter "kept").
ovErpay timEout
Makes it possible to set the time when the
credit will be released if a selection hasn’t
been made.
mDb
crEDit programmiNg (ovErpay)
You can decide whether to:
-Collect any credit in excess of the selec-
tion amount after a certain time in seconds
(parameter "deleted").
-Leave any credit in excess of the selection
amount available for a subsequent selec-
tion (parameter "kept").
ovErpay timEout
Makes it possible to set the time when the
credit will be released if a selection hasn’t
been made.
maximum crEDit
This function allows the maximum credit
accepted for the introduced coins to be
dened.
maximum cHaNgE
It is possible to set a limit for the total
amount of change that the coin box will give
when the return change button is pressed
or after a single dispensed beverage.
Any credit exceeding the amount that has
been programmed with this function, will be
cashed in.
accEptED coiNs
It is possible to dene which coins that are
recognised by the validator shall be accept-
ed when the coin return tubes are full.
For the coin/ value correspondence, the
conguration of the coin box needs to be
checked.
Exact cHaNgE accEptED coiNs
It is possible to dene which coins that are
recognised by the validator shall be accept-
ed when the machine is in “exact change”
mode.
For the coin/ value correspondence, the
conguration of the coin box needs to be
checked.