Evocheck BPM68 - Two Set Memory Function; Recalling Measurements in Memory; Clearing Measurements from Memory; Troubleshooting

® BPM68 ® BPM68
Two Set Memory Function Troubleshooting
Recalling Measurements in Memory:
You can recall up to 90 measurements per memory bank, 180 total, plus
an average of last 3 currently stored measurements in memory to share
with your physician or trained healthcare professional.
1. Press and release the M1 or M2
button. The unit will rst display
the average of last 3 currently
stored measurements.
2. Continue to press the M1 or M2
button to successively view the
next previously stored
measurements. Measurements will
appear on the display from most
current to oldest; the memory
number will appear on the lower
left corner.
3. All results for a given measurement will display, including
measurement results, pulse rate, Hypertension Indicator, Irregular
Heartbeat alert, and date/time stamp.
4. Each memory bank stores up to 90 readings; when the number
of readings exceeds 90, the oldest data will be replaced with the
new record.
5. Press the Power button to turn the monitor OFF at any time during
review of the stored measurements.
Clearing Measurements from Memory:
From power display o, press and hold down
the M1 button or the M2 button until the
display shows CLr. This indicates that all
measurements have been erased.
Problem Probable Cause Recommended Action
Nothing appears in Batteries are drained. Replace all batteries with new ones.
the display even
when the power Battery are not correctly Reinsert batteries in the correct
is turned on aligned with terminals. position.
Low Battery Batteries are drained. Replace all batteries with new ones.
Symbol appears.
In colder temperatures Warm up the batteries, or use the
batteries have weaker device in a warmer setting.
electrical charges.
Device operation Dierent battery brands Use Alkaline batteries and
time is inconsistent. have dierent life spans. replace all batteries at the same
time with same brand batteries.
No reading after Batteries are drained. Replace all batteries with new
measurement. ones.
Suspicious blood Perhaps the cu was Adjust patient and arm cu
pressure results. improperly positioned. to measure.
Blood pressure naturally Rest a while, relax and measure
varies throughout the day. again.
Suspicious heart Bodily movement during Refrain from moving during
rate results. device use. measurement.
Measurement shortly after Do not take measurements after
exercise or exposure to exercise or coming back from
the outdoors. the outdoors.
Power switches System design. Push the power button again,
o automatically. and then begin measure again.
During measuring, It could be a normal action Relax, and try to take a measure
air re-inates. if the user's blood pressure is again.
higher than the initial pressure
value, the device automatically Check that the arm cu is
pumps to a higher pressure by fastened properly and retake
40mmHg each time. the measurement.
The arm cu is not fastened
properly.
15 14