How to fix bad quality text or stripes on Evolabel Printer labels?
First, verify that you are using the correct label and ribbon quality. If the issue persists, clean the print head. If the problem still isn't resolved, the print head may need replacing.
Covers essential safety instructions, warning signs, and identified risks during machine operation and maintenance.
Identifies main components of D43, T43/T63 models, including print heads, guides, shafts, and control elements.
Explains the touch panel and control panel interfaces, detailing buttons, displays, and indicators for operation.
Comprehensive guide on how to replace the label roll, from removal of the old roll to loading and threading the new one.
Detailed steps for replacing the ribbon on T43/T63 models, including preparation, loading, and threading.
Instructions on how to adjust and set the correct width for labels based on the product dimensions.
Procedure for setting the appropriate ribbon width for T43/T63 models.
Guide for configuring the label length specifically for the blow applicator model.
Step-by-step instructions for cleaning the print head and print roller using isopropyl alcohol.
Solutions for bad quality, stripes, and incorrect text positioning on labels.
Troubleshooting for labels not applied correctly or paper out alarms.
Procedures for dealing with unlisted faults, emphasizing documentation and service contact.
General| Print Resolution | 203 dpi or 300 dpi |
|---|---|
| Print Speed | Up to 305 mm/sec (12 ips) |
| Cutter | Optional |
| Rewinder | Optional |
| Print Technology | Thermal Transfer / Direct Thermal |
| Connectivity | Ethernet, USB |
| Label Sensor | Reflective and Transmissive |
To Next Page