Evolite Moving eam 7R - Auto Mode

Moving Beam 7R User’s Manual Ver. 1.00 Page23
Pan / Tilt
Reverse Pan (On/Off)
Reverse Pan
Reverse Tilt (On/Off)
Reverse Tilt
Select Pan 630°/540°/360°
Pan max angle
Select Tilt 270°/180°/90°
Tilt max angle
UI SET
Mic sensitivity 0~99%
Sound mode mic
sensitivity
OFF Signal Mode (On/Off)
Keep last DMX values
Half Color Wheel
Half colors
Information
Lampe Hours
Temperature
Fan parameter
Xxxx(Hours)
Xxx°C/°F
Current = xxxxmA, Voltage = xxxxmV
Lamp use time
Current temperature
Fan parameters
Manual
Control
Reset
Total Reset
Pan/Tilt Reset
Color Reset
Gobo Reset
The Others Reset
Reset total
Pan/Tilt Reset
Coleur Reset
Gobo Reset
Other Reset
Channel
PAN=XXX……
Manual mode
Advanced
(Access
Code 088)
Calibration
Clear lamp time
PAN=XXX……
Yes/No
Calibration (factory only)
Reset lamp time
o Auto Mode
Press the MENU key then ENTER, then use the DOWN key to reach the AUTO RUN menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
Sound Mode :
Press the MENU key then ENTER, then use the DOWN key to reach the Music Control menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.