OPERATION AND CONTROLS
D3 Lifted User’s Manual Page13.
Be familiar with vehicle features before attempting any operations.
PRE-OPERATION SAFETY AND PERFORMACE INSPECTION
Use the pre-operation checklist to inspect the operational conditions and performance of the
vehicle. If bad operational conditions are found on a vehicle, stop operations. Removal
from operation can prevent Further damages to the vehicle or serious injuries . If the vehicle
is not in an operate-able condition, inquire your dealer for maintenance or repairs.
Before initiate using vehicle, the batteries should be
fully charged, Replace the bad/broken/damaged parts
during inspection.
Check the brake pedal , when stepped it should be
flexible and feels firm . And it returns to its original
position with flexibility when released
Check the accelerator pedal ,when stepped and
released it should return to its original position with full
flexibility.
Check the tires’ pressure, pressure is around 20psi. Check
tires surface, remove any embedded objects you can find.
Be sure no cracks or other damages to the tires ,defective
tires may cause accident while driving.
Pull the steering wheel up and down ,check the tightness of
steering wheel .Rotate the steering wheel right and left. Be
sure no excessive free play and rattling sound .
Check the reverse beeper ,when the direction selecting
switch be set at “REV”, it should beep soundly
Check the signal lights , the brake lights and turning lights
should be in proper working condition .
PRE-OPERATION CHECKLIST
To Next Page
Loading...
Need help?
General