Page 11 of 38
102808_CAPAC_MANUAL_MODEL_90W12D_SYSTEM.doc
Section III
INSTALLATION
ANODE INSTALLATION & PARTS LIST
Parts List
Anode Assembly Complete – 37792
Item # (Fig. 3.1) Quantity Part Number Description
1 1 37786 Anode Assembly
2 1 37795-9-1 Flat Washer
3 1 37344-13 Lock Washer
4 1 37791-25-1 Hex Nut
5-10 1 37798 Encased splice
10 feet 36282 Butyl Bead
1 lb. 37020 Capastic Kit
(When furnished)
Anode Installation (See Figure 3.1)
The anode platinum coated disc is 2-1/2 inches in diameter and is
supported and electroically insulated from the hull by the black plastic structure
which surrounds it. The threaded stem serves to mount the anode as a through-
hull fitting. Water tightness is insured by the butyl sealant and the electrical
connection is protected by the clear plastic encased splice provided. The anode
is supplied with 10 inches of black cable and must be installed while the boat is
out of the water.
Before commencing the anode installation, read all the instructions and
check the parts with the parts list at the beginning of this section.
A Capastic epoxy compound is furnished with anodes for use on metal
and wood hulls for application as a dielectric shield around each anode.
Application instructions are printed on Capastic container label.
To Next Page
Loading...