Evoqua W2T388687 - Default Chapter; Table of Contents

IONPURE
®
DC POWER CONTROLLER – IP-POWER600-G2
IP-POWER600-G2 MAN REV. 11 Page 2 of 28
Table of Contents
DISCLAIMER STATEMENT .................................................................................................................. 4
PROPRIETARY RIGHTS STATEMENT ................................................................................................ 4
MANUAL REVISION HISTORY ............................................................................................................. 4
1 INTRODUCTION ............................................................................................................................. 5
1.1 Caution and Warning Messages ................................................................................................ 5
1.2 General Description ................................................................................................................... 5
2 INSTALLATION ............................................................................................................................... 7
2.1 Mounting .................................................................................................................................... 7
2.2 AC Supply .................................................................................................................................. 7
2.2.1 Isolation Transformer ........................................................................................................... 7
2.2.2 Over-current Protection ........................................................................................................ 8
2.2.3 Electrical Surge Suppression................................................................................................ 8
2.3 High Voltage Connections .......................................................................................................... 9
2.3.1 Initial Selection of AC Input Voltage ..................................................................................... 9
2.3.2 High Voltage Connections .................................................................................................... 9
2.4 Selector Switches ..................................................................................................................... 11
2.4.1 DIP Switch for Current Range Selection ............................................................................. 11
2.4.2 Rotary Switch for Selection of Voltage Metering Output Range and Unit ID ....................... 11
2.5 Low Voltage Connections ......................................................................................................... 12
2.5.1 Analog Signal Wiring Guidelines ........................................................................................ 12
2.5.2 Control of DC Output Current ............................................................................................. 12
2.5.3 Remote ON/OFF ................................................................................................................ 13
2.5.4 Analog Outputs .................................................................................................................. 13
2.5.5 Output Status Relay ........................................................................................................... 13
3 OPERATION .................................................................................................................................. 14
3.1 Initial Startup ............................................................................................................................ 14
3.1.1 Example of Initial Startup Procedure .................................................................................. 14
3.2 Output Adjustment ................................................................................................................... 14
4 TROUBLESHOOTING ................................................................................................................... 15
APPENDIX A DESIGN CONSIDERATIONS .................................................................................... 18