8
Emergency Brake Handle
To activate the emergency brake, first start by depressing the foot pedal to alleviate tension from the
brake lines. Keep the brake pedal depressed while activating or releasing the emergency brake. Pull
the handle out towards you while the handle is in the vertical position to activate.
To deactivate, push the foot brake down again, and follow the instructions on the handle "Push
Button and Turn" while pushing the handle pack into its housing.
Seat Latch Release
To release the seat latch, you need to start by inserting the key into the ignition. Without pushing
inwards, turn the key counter clockwise (left). You should feel resistance while turning the key, until it
hits a stopping point where it cannot turn anymore. If you do not feel any resistance, this means the
key has been pushed inwards, which bypasses the seat latch release. While holding, the key turned
counter clockwise at its stopping point, lift on the back of the seat. A good leverage point for lifting
the seat is underneath the backrest. Once the latch is released, the entire seat assembly will lift
towards the front column, and rest against the front tiller.
To Next Page
Loading...
