- Exalto Wiper Technologies type CT3N
6
If using one speed motors:
Speed bar Waiting time Mode
All Leds OFF - Stand-by
1 x Led ON 8 seconds Intermittent
2 x Led ON 6 seconds Intermittent
3 x Led ON 4 seconds Intermittent
4 x Led ON 2 seconds Intermittent
5 x Led ON - Continuous
4. Wash program
By pressing the wash button, washing program will start.
|3 sec. | 3 sec. | 4 sec. |
|=== Spray === Spray ===|
|===== Wipe ===== Wipe ===|
Keep pressed button 5 to increase wash timing and spray + wipe time. After wash
cycle, wipers will return to operate in the previous selected mode.
5. Single wipe function
The single wipe function is allowed only when all the wipers are off. Push the button
6 to perform the single wipe. Keep pushed to perform more than one wipe.
6. Heating function (additional relay box required)
The control panel can activate/deactivate the heaters, only if a relay box (additional)
is installed. The button 4 actives the heaters when pushed. To deactivate push the
button again. When the heaters are active, the button is lighted up.
7. Backlight brightness and colors
The button 3 performs the brightness adjustment and the color selection. Pushing
it momentary the brightness level will change. Four brightness levels are available.
Keeping it pushed the backlighting color will change.
To Next Page
Loading...
Need help?
General
