SAFETY INFORMATION
This multi meter has been designed according to IEC
-1010
concerning
electronic
measuring
instruments
with
an
overvoltage category (CAT
n)
and pollution 2.
Follow all safety and operating instructions
to
ensure that the
meter is used
safely and is kept in good operating condition.
Full complianca with safety standards can
be
guaranteed only
with test leads supplied.
If
necessary, they must be replaced
with the type specified
in
this manual.
SAFETY SYMBOLS
~
Important safety information, refer
to
the
operating
manual.
&
...L
Dangerous voltage may
be
present .
Earth ground.
Double insulation (protection class
II)
.
Fuse must
be
replaced with rating specified
in
the
manual.
MAINTENANCE
• Before opening the case, always disconnect test leads
from all energized circuits.
• For continue protection against fire: replace fuse only
with the specified voltage and current ratings:
F
200mA/250V(Ouick Acting)
• Never use the
meter
unless the back cover is
in
place
and fastened completely.
• Do not use abrasives or solvents on the meter.
To
clean
It using a damp cloth and mild detergent only.
-1-
To Next Page
Loading...