BATTERY & FUSE REPLACEMENT
If
"
~
" appars
on
display, it indicates that the battery should
be replaced
Fuse rarely need
replacement
and blow almost always as a
result
of
operator's error.
To
replace battery & fuse {200mAI250V) remove the 2 screws
in the bottom
of
the case. Simply remove the old, and replace
with a new one.
Be
careful to observe battery polatity.
&wARNING
Before attempting to open the case, always be sure that test
leads have been disconnected from measurement circuits.
Close case and tighten screws completely before using the
meter
to avoid electrical shock hazard.
ACCESSORIES
• Operator's instruction manual
• Set
of
test leads
•
Gift box
• 9 volt battery. NEDA 1604 6F22 006P type
• Holster (option)
-8-
\
To Previous Page
Loading...