ExelTech XP600 - Operation 4.0

XP600/1100/2000 INSTALLATION AND OPERATION MANUAL
TURN ON INVERTER:
XP-600, XP-1100 and XP-2000:
Note:
TURN ON APPLIANCE/LOAD:
1.
2.
Note:
Turn inverter on using Toggle
Switch on Front Panel, or the "REMOTE" switch if installed. LED
next to the switch will illuminate, indicating the inverter is
operational.
If using "REMOTE" switch, the Front Panel Switch must be
off. (If either switch is "on", the inverter will turn on. Both switches
must be off for the inverter to turn off.)
Check Input Power Requirements of the appliance. Make sure
that it is less than Rated Output Power of the inverter. If more than
one appliance will be run simultaneously, the sum of their Input
Power Requirements must be less than Rated Output Power of the
inverter.
If Appliance/Load has been hard wired to the barrier terminal
strip as illustrated in Appendix "C", then turn appliance on.
Otherwise, plug the appliance into the provided receptacle on
Front Panel, then turn appliance on.
It is recommend that the inverter be turned ON before the
appliance/load.
.
.
.
.
.
.
.
Operation
4.0
Page 11