Exerpeutic 475SL - Installing the Left Handlebar

11
ASSEMBLY
Step 2
Installing the Left Handlebar:
2A. Install the Left Handlebar (6L) onto the Rear Frame (8) with two Socket Hex Bolts (20), four
Flat Washers (19), two Cap Nuts (24), one Socket Hex Bolt (15) and one Flat Washer (16).
Tighten the hardware using the 10, 13, 17mm Wrench and the 6mm Allen Wrench provided.
Note: Install the Bolt (15) in the same orientation as displayed in the illustration above and the Cap
Nuts (24) should installed on the outward facing side of the frame.
(19) Flat Washer
4PCS
(24) Cap Nut
2PCS
(20) Socket Hex Bolt
2PCS
(16) Flat Washer
1PC
(15) Socket Hex Bolt
1PC
Hardware:
10, 13, 17mm Wrench 1PC
6mm Allen Wrench 1PC
Tools: