Step 3
Hardware Removal:
3A. Remove the Plastic Spacer (17), Plastic Round End Cap (18), and Socket Hex Bolt (28)
from the Rear Frame (8) with the 6mm Allen Wrench provided. See Fig. A. Keep the Socket Hex
Bolt (28) for the Cup Holder (23) installation. Discard the Plastic Round End Cap (18) and
Plastic Spacer (17).
Installing the Cup Holder:
3B. Align the tabs of the Cup Holder (23) and the swing arm area of the Rear Frame (8). See Fig.
B. Attach the Cup Holder (23) onto the Rear Frame (8) and the Left Pivot Arm (10L). with one
Flat Washer (21) and one Socket Hex Bolt (28) by 6mm Allen Wrench provided
To Next Page
