Exerpeutic Traction Table - Operating the Traction Table; Steps 1 & 2: Initial Setup and Foot Locking

12
HOW TO USE
Step 1
Adjusting table to load in
1A. Pull out the Height Adjustment Pin (13) and simultaneously push the Heel Holder
Boom (3) into the Main Frame (1) all the way in.
Step 2
Locking feet in Heel Holders
2A. Sit on the Main Frame (1), facing the Adjustable Heel Holder (4). Extend the Heel
Holder Boom (3) by hand to match the length of your leg.
2B. Pullout the Pop Pin (19), lift up the Adjustable Heel Holder (4) and slip your ankles
in between the Foot Foam Rollers (28). Pull the Pop Pin (19) and press down on the
Adjustable Heel Holder (4) until it is snug, release the Pop Pin (19) and make sure it is
Locked.