3－4
3.3 Air Cleaner
1. Lift open door
2. Rotate filter out from rear.
3. Clean the foam element by squeezing it in warm soapy water, rinsing it, and allowing it to dry. You may also
use a nonflammable solvent and then allow it to dry.
4. Clean the paper element by tapping it on a hard surface to knock off dirt, never used compressed air. Never
try to brush off the dirt. Brushing will force dirt into the filter fibers.
5. Use a damp rag to wipe any dirt from the inside of the air cleaner base and cover. Be careful not to allow dirt
into the duct leading to the carburetor.
6. Install filter in reverse order of removal
7. Close door
CAUTION: Operating the engine without an air filter, or with a damaged air filter, will
allow dirt to enter the engine, causing rapid engine wear. This type of damage is not covered by
the Distributor’s Limited Warranty.
3.4 Spark Plug
To Next Page
Loading...
General