MAINTENANCE INSTRUCTIONS
Before working on engine or equipment, disable engine as
follows: 1) Disconnect spark plug lead(s). 2) Disconnect
negative (–) battery cable from battery.
Accidental Starts can cause severe injury or
death.
Disconnect and ground spark plug lead(s)
before servicing.
Normal maintenance, replacement or repair of emission control devices and systems may be performed by any repair
establishment or individual; however, warranty repairs must be performed by an authorized Exmark dealer.
Service Rules
Engine Model / Serial Number Location
The engine model and serial number are stamped into the block, there will also be a label attached to
a new engine with this information on it as well.
XXX-XXXX XXXXXXXXXXX
Engine
Model
& Serial
Number
1. Only use genuine Exmark parts and lubrication products.
2. Always install new gaskets, O-rings and seals when assembling engine.
3. Always torque fasteners to specification and in sequence.
4. Always lubricate friction components with clean engine oil or engine assembly lube
when assembling engine.
To Next Page
Loading...
General