EasyManuals Logo

Exmark Lazer HP Setup Instructions

Exmark Lazer HP
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Page 3 of 5
109-6182 Rev. A
FIGURE 4
4. 31 HP Briggs & Stratton units only:
a) Route the switch wire from the seat over the
top of the front seat frame crossmember.
b) Using one of the two wire ties included
secure the wire near where the seat hold up
rod is connected to the seat frame.
c) Using the second wire tie, secure the wire
again to approximately the middle of the seat
hold up rod.
d) Connect the seat wire to the main wiring
harness lead. Slowly lower the seat checking
that the wire cannot contact any moving parts
or pinch points. Readjust wire ties if
necessary.
Servicing the Battery
The machine is shipped with a filled lead acid
battery.
1. Unhook seat latch and tilt seat up to gain
access to the battery.
DANGER
POTENTIAL HAZARD
Charging the battery may produce explosive
gasses
WHAT CAN HAPPEN
Battery gasses can explode causing serious
injury.
HOW TO AVOID THE HAZARD
Keep sparks, flames, or cigarettes away from
battery.
Ventilate when charging or using battery in an
enclosed space.
Make sure venting path of battery is always
open once battery is filled with acid.
2. Check the voltage of the battery with a digital
voltmeter. Locate the voltage reading of the
battery in the table below and charge the battery
for the recommended time interval to bring the
charge up to a full charge of 12.6 volts or
greater.
IMPORTANT: Make sure the negative battery
cables are disconnected and the battery charger
used for charging the battery has an output of 16
volts and 7 amps or less to avoid damaging the
battery (see chart below for recommended
charger settings).
Voltage
Reading
Percent
Charge
Maximum
Charger
Settings
Charging
Interval
12.6 or greater
100%
16 volts /
7 amps
No Charging
Required
12.4 – 12.6 75 – 100%
16 volts /
7 amps
30 Minutes
12.2 – 12.4 50 – 75%
16 volts /
7 amps
1 Hour
12.0 – 12.2 25 – 50%
14.4 volts /
4 amps
2 Hours
11.7 – 12.0 0 – 25%
14.4 volts /
4 amps
3 Hours
11.7 or less 0%
14.4 volts /
2 amps
6 Hours
or More
WARNING: Battery posts, terminals, and related
accessories contain lead compounds, chemicals
known to the State of California to cause cancer and
reproductive harm. Wash
hands after handling.

Other manuals for Exmark Lazer HP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Exmark Lazer HP and is the answer not in the manual?

Exmark Lazer HP Specifications

General IconGeneral
Drive SystemHydrostatic
Turning RadiusZero-turn
Engine BrandKawasaki
Cutting Width52 inches
TransmissionHydro-Gear
Blade Tip Speed18, 500 fpm

Related product manuals