exonda M41 - Operation; Connecting and Disconnecting from Power; Positioning for Customer Use

4 Operation
GB
50
Figure 01
① Power cord
② Rating plate
Figure 02
4.1 Connecting to mains / Disconnecting Figure 01
The socket outlet with earthing contact must have at least 10 ampere protection.
We recommend that the wiring in your salon is protected with a residual current
circuit breaker (RCCB) fitted by your electrician.
4.1.1 Connecting to mains
1st Check the plug

and power cord ① for damage.
NOTE – Power supply voltage :
The power supply voltage of the appliance can be found on the rating
plate

under the filter cover ②
2nd Turn the filter cover

to the left (anticlockwise) and remove.
3rd Check that the mains voltage corresponds to the information on the. rating
plate ②
4th Put on the filter cover

and turn it to the right (clockwise) as far as it will
go.
5th Move the pedestal device to the place where treatment is to be performed.
6th Insert plug

of pedestal version in a socket.
Insert plug

of the wall-mounted version in a properly earthed socket outlet
with earthing contact
7th Arrange power cord ① so no-one can trip over it.
4.1.2 Disconnecting from mains
To avoid damage to the Hood dryer, model M41
1st Do not pull on power cord ①.
2nd Switch off appliance at ON/OFF switch

.
3rd Disconnect from mains by gripping and pulling out plug

.
4th Wind up power cord ① on holder

.
4.2 Positioning Hood dryer, model M41 for customer
Figure 02
Position appliance:
1st Adjust appliance to required height.
• Tilt the pedestal adapter

forwards into the working position.
• Position the appliance centrally over the forehead/nape of the neck so that
the head piece

completely covers the customer’s hair.
• The face and eyes must be outside the head piece

.
• The hair and all curlers must be completely under the head piece

.
• The distance between the customer and the hairdryer dome

should be the
same on all sides.
To ensure customer comfort
• For sensitive customers turn down the temperature and airflow using the
temperature control

and the airflow setting control

.
• Inform your customer that she can stop treatment by pushing up the head
piece

using both hands and moving out of the appliance to the front.
Rating plate