Exor eX710 - Serial Port Configuration; Ethernet Port Indicators

20
MANUGENEX7xx
Operating Instructions
VER 2.00
5.1 Serial Port
The serial port is used to communicate with the PLC or with another type of controller.
Di󰀨erent electrical standards are available for the signals in the PLC port connector: RS-232, RS-422,
RS-485.
The serial port is software programmable. Make sure you select the appropriate interface in the pro-
gramming software.
The communication cable must be chosen for the type of device being connected.
Connections
SERIAL PORT
To operate in RS-485 pins
1-2 and 3-4 must be con-
nected externally.
Pin Description
1 CHB-
2 CHA-
3 CHB+
4 CHA+
5 +5V output
6 GND
7
8 SHIELD
5.2 Ethernet Port
1 8
Yellow
OFF: Valid link has NOT been detected
ON: Valid link has been detected
Green
ON: No activity
BLINKING: Activity
The Ethernet port have two status indicators. Please see description in gure.
Pin Description
1 RX
2 TX
3 CTS
4 RTS
5 +5V output
6 GND
7
8 SHIELD
RS-232 RS-422, RS-485